Optical Photothermal Infrared + Raman Microscopy

O-PTIR / Raman

Optical photothermal infrared spectroscopy

Infrared chemistry at sub-micron resolution, with Raman from the same spot.

At BNL · mIRage instrument at the CFN. In situ capabilities are being developed.

How it works

A pulsed, tunable IR laser is focused on the sample. Where the sample absorbs, it heats and expands slightly. A visible probe laser focused on the same spot detects that photothermal response. Sweeping the IR laser gives a spectrum that resembles a transmission IR spectrum, while the spatial resolution is set by the visible probe (about half a micron), not by the IR wavelength. The same probe beam also generates a Raman spectrum.

Geometry & samples

Co-focused IR pump and visible probe in a reflection microscope. Non-contact.

Powders dispersed on a substrate, films, cross-sections, pellets. Little or no preparation.

Best for

  • —Mapping chemical heterogeneity between and within catalyst particles
  • —Complementary IR and Raman from the same location
  • —Samples too thick or too rough for transmission

Strengths

  • —Sub-micron spatial resolution across the whole IR range
  • —No contact with the sample, unlike AFM-IR
  • —Spectra largely free of the scattering artefacts of IR microscopy

Limitations

  • —The CFN instrument covers 758 to 1806 cm⁻¹: no C–H or O–H stretches, and no carbonyl CO region (1900 to 2300 cm⁻¹)
  • —Signal depends on thermal properties, so intensities are not simply absorbance
  • —Not a sub-monolayer adsorbate technique

Practical tips

  • —Plan around the fingerprint region: carbonates, carboxylates, formates, C=O, framework and M=O bands are in range
  • —Keep probe power low: dark catalysts burn easily
  • —Use Raman for the oxide lattice and carbon, IR for the organics and adsorbates

Instruments at the CFN

Try it

Compare all four techniques →